/ # dmesg | grep usb0

[    0.143432] musb-ti81xx musb-ti81xx: musb0, board_mode=0x13, plat_mode=0x3

[    0.176574] musb0: Enabled SW babble control

[    1.792083] usb0: MAC ba:4e:92:c7:5f:31

[    1.796081] usb0: HOST MAC 5e:9c:63:65:fb:0e

[    2.311920] usb0: qlen 10

[    2.312255] usb0: gether_disconnect

[    2.312316] usb0: qlen 10

Ip를 설정합니다.

/ # ifconfig usb0 192.168.0.199 up

1.     다음은 망고 3358과 연결된 linux machine의 ifconfig –a 명령의 stdout입니다.

ybkim@ybkim-desktop:~/hdd/work/mango3358/m3358_jb4.2.2_20160122/kernel$ ifconfig -a

eth0      Link encap:Ethernet  HWaddr 00:1c:c0:c9:49:32

          inet addr:192.168.0.4  Bcast:192.168.0.255  Mask:255.255.255.0

          inet6 addr: fe80::21c:c0ff:fec9:4932/64 Scope:Link

          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1

          RX packets:4341826 errors:0 dropped:0 overruns:0 frame:0

          TX packets:2468717 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:1000

          RX bytes:5656823922 (5.6 GB)  TX bytes:283916466 (283.9 MB)

lo        Link encap:Local Loopback

          inet addr:127.0.0.1  Mask:255.0.0.0

          inet6 addr: ::1/128 Scope:Host

          UP LOOPBACK RUNNING  MTU:65536  Metric:1

          RX packets:3110 errors:0 dropped:0 overruns:0 frame:0

          TX packets:3110 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:0

          RX bytes:508115 (508.1 KB)  TX bytes:508115 (508.1 KB)

usb0      Link encap:Ethernet  HWaddr d6:a4:04:75:72:88

          BROADCAST MULTICAST  MTU:1500  Metric:1

          RX packets:0 errors:0 dropped:0 overruns:0 frame:0

          TX packets:1 errors:117 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:1000

          RX bytes:0 (0.0 B)  TX bytes:96 (96.0 B)

IP를 설정합니다.

ybkim@ybkim-desktop:~/hdd/work/mango3358/m3358_jb4.2.2_20160122/kernel$ sudo ifconfig usb0 192.168.0.209 up

망고 보드에서 Linux Machine에 ping을 해봅니다.

/ # ping 192.168.0.209

PING 192.168.0.209 (192.168.0.209): 56 data bytes

64 bytes from 192.168.0.209: seq=0 ttl=64 time=0.794 ms

64 bytes from 192.168.0.209: seq=1 ttl=64 time=0.580 ms

64 bytes from 192.168.0.209: seq=2 ttl=64 time=0.427 ms

64 bytes from 192.168.0.209: seq=3 ttl=64 time=0.518 ms

Linux Machine에서도 마찬가지로 망고보드로 ping 명령을 하면 응답이 옵니다.